New Camera Installs - 1: Port number of edge and NVR in the CRM notes Cables labeled with a sharpie (NVR, Edge, Cameras) 2: Photos of NVR and Edge in network rack - Close and Far (photo of switch if cams aren't in NVR) Photo of the switch where NVR ...
SDI/Bob’s Stores Network Settings NVR IP: 10.3.42.5 SUBNET: 255.255.255.128 Gateway: 10.3.42.126 DNS: 10.3.42.126 IP Definitions: 10.3.x.x (first two octets at any of their locations should be the same...10.3.x.x) x.x.42.x (third octet will always be ...
Jersey Mike’s set up (VIDEO ATTACHED) Set up #1: FORTINET SECURE ROUTER ISP Modem goes into Wan1 on Fortinet router POS 1 goes into 1 on the Fortinet router POS 2 goes into 2 on Fortinet router Air Printer goes into 3 on Fortinet router 4-5 can be ...
Preprogramming a Hik Camera for a Dahua NVR Since we will see this with the occasional Good2Go's, here is what I had to do to get a Hik camera added to a Dahua NVR. We will need to do this before we send out a camera. Activate the camera through ...
How to install a Jersey Mikes POS on a Cisco Router Jersey Mike’s set up CISCO SECURE ROUTER ISP modem goes into Cisco router GE8 Pos1 goes into Cisco router on port WE0 Pos2 goes into Cisco router on port WE1 FORTINET SECURE ROUTER POS 1 goes into 1 ...
Installing a Savi EDGE Device Find the Savi EDGE Device Plug one end of the ethernet cable into the EDGE device and the other end into the Internet Modem. (the same modem that has your cameras) Plug in the transformer into the EDGE device. A light ...
How to attach a gateway/edge device to an account. To get started, go to https://api-prod.getsavi.com/admin/accounts on your chrome browser. Once there, search the name of the parent company and choose the appropriate account. Before you create a new ...
EDGE Configuration Savi can provide a host name for this device upon request on a per location basis. Network Configuration: The Savi EDGE must be configured allowing it to communicate out to the following domains: White Listed Domain ...
Zoho Learn EA 200 or EA400 temperature sensor installation The EA200 or EA400 must be connected to 3 things: Power (12 VDC @ 1A transformer), a temp probe and a dw10 equivalent device. The temp probe is wired into terminals that go on Sensor 2 (Zone ...
Zoho Learn EA 200 or EA400 temperature sensor installation The EA200 or EA400 must be connected to 3 things: Power (12 VDC @ 1A transformer), a temp probe and a dw10 equivalent device. The temp probe is wired into terminals that go on Sensor 2 (Zone ...